In this case, prerequisites associated with selected features will be installed at the end of the Install UI sequence, or, if the installation is being run without a UI, just before the Install Execute sequence. In InstallShield 2009, you can configure "feature prerequisites" that will not be installed until after features have been selected. The net effect of this is that the launch conditions are shown without installing prerequisites, but this isn't a really simple way to achieve this. That being said, you may be able to configure the conditions on the prerequisites in such a way that the prerequisites would not be installed if you know in advance if a launch condition cannot be satisfied. Basically, this means that you can't show launch conditions until after prerequisites have been installed. data:image/png base64,iVBORw0KGgoAAAANSUhEUgAAAKAAAAB4CAYAAAB1ovlvAAAAAXNSR0IArs4c6QAAArNJREFUeF7t1zFqKlEAhtEbTe8CXJO1YBFtXEd2lE24G+1FBZmH6VIkxSv8QM5UFgM. This can be done by pressing the power and volume buttons and holding it for about 8 seconds, and your Galaxy phone will start automatically. Launch conditions are handled by the MSI, which will not be run until after the prerequisites are installed. ![]() If you are using InstallShield prerequisites in your installation, they will be installed by the setup.exe, not the MSI.
0 Comments
Leave a Reply. |